raised and inspected, found substantial leak coming from oil filter adapter to block area.
Replaced oil filter adapter gasket and both oil pressure sender seals, cleaned residual oil from leak area, test ran for 15 minutes, no leaks at this time. Topped off engine oil.
Stephen P. gave our service a 5 star review on 4/12/2024
Ran on hoist, verified, can feel popping from LF CV shaft, either shaft or transmission, need to start with replacing LF shaft. RF shaft boot is torn also.
Ben L. gave our service a 5 star review on 4/12/2024
Road tested vehicle. Noise coming from both front wheels on bumps. Inspected suspension, CV axles , sway bar links, bushings, ball joints (RF boot torn), tirods are all tight. Need front struts to eliminate noise.
SHOCK &/OR STRUT ASSEMBLY – Remove & Install or Remove & Replace – Both – [DOES NOT include disassemble or alignment.]
Road test vehicle. Check all suspension and steering parts for wear. Check tire pressure and condition. Check riding height. Check caster and camber angles and adjust as required. Check and set toe-in as required. Center steering wheel.
drain and fill engine oil, replace filter, inspect and lubricate chassis, test battery, place service reminder sticker on windshield
Andrew P. gave our service a 5 star review on 3/14/2024
Verified, checked codes, had 16 different DTC's stored, cleared codes, test ran, first code to return is cyl.1 misfire, swapped coils with #2, cleared code, test ran while monitoring live, misfire moved with coil. Also noticed that the spark plugs are OE. Suggest replacing coil and all four plugs.
Replaced spark plugs and coil #1, cleared codes, test drove for 10 miles, no codes have returned, vehicle is running smoothly.
Nick M. gave our service a 5 star review on 2/7/2024
drain and fill engine oil, replace filter, inspect and lubricate chassis, test battery, place service reminder sticker on windshield
DISC ROTOR – Remove & Replace – Gas Rear,Both – [Includes: Repack Wheel Bearings (where applicable) and replace Pads (if necessary). DOES NOT include refinishing.]
Gasket on bypass hose leaking, replaced gasket
John T. gave our service a 5 star review on 1/2/2024
Connected smoke machine and pressurized system, commanded all available EVAP VSV's, could never get smoke to stop coming out of vent hose. Need to replace canister assembly. VSV light was on because C1336 is stored in ABS module (zero point calibration yaw rate sensor undone, performed zero point calibration, retested, lights did not return.
John K. gave our service a 5 star review on 12/27/2023